Disability Ramp Installation FAQs
Straight answers to the questions we're asked most.
How much does a disability ramp cost in the UK?
A fitted threshold ramp costs £60 to £250, while a modular aluminium ramp for a single step costs around £800 to £1,800 in the UK in 2026. Ramps for two or three steps typically cost £2,000 to £5,000, and permanent concrete or brick ramps £2,500 to £8,000. Price depends mainly on the rise, layout and site conditions.
What gradient should a wheelchair ramp be?
Approved Document M guidance for buildings other than dwellings allows gradients from 1:20 for runs up to 10 metres to 1:12 for runs up to 2 metres, with landings between sections. Gentler slopes are easier and safer for self-propelling wheelchair users. Steeper portable ramps may be manageable only with an assistant pushing the chair.
Can I get a grant for a disability ramp?
Yes, you may qualify for a Disabled Facilities Grant from your local council to help pay for a ramp and other home adaptations. In England the maximum grant is £30,000, and most adult grants are means-tested. An occupational therapist usually assesses the need first. Grants are not available for work started before approval.
Do I need planning permission for a wheelchair ramp?
Most small domestic ramps do not need planning permission, but larger ramps with raised platforms more than 0.3 metres above ground may do in England. Ramps on listed buildings, in conservation areas or crossing public footpaths also need permission. Temporary modular ramps are less likely to need permission. Check with your council if unsure.
How long does it take to install a ramp?
A modular aluminium ramp is usually installed in a single day, and a threshold ramp in under an hour. Permanent concrete or brick ramps take around three to seven days including groundwork, building and curing. Lead times depend on the installer and any grant or council approval needed before work starts.
What is the difference between a modular and permanent ramp?
A modular ramp is made from prefabricated aluminium sections bolted together on site, so it is quick to install and can be moved or reconfigured. A permanent ramp is built from concrete, brick or block and becomes part of the property. Modular ramps suit rented homes and short-term needs, while permanent ramps suit long-term use.
How long does a ramp need to be?
A ramp's length depends on the height it climbs and the gradient. At a gradient of 1:12, each 100mm of rise needs about 1.2 metres of ramp. At 1:15, each 100mm needs 1.5 metres. Longer ramps need level landings at intervals. An installer will measure the total rise and calculate the length needed.
Does a wheelchair ramp need handrails?
Handrails are strongly recommended on most ramps and are expected on both sides of ramps in non-domestic buildings under Approved Document M guidance. They help people who walk with difficulty, give support on slopes and prevent falls. Short threshold ramps generally do not need handrails, but longer ramps almost always benefit from them.
Can a landlord refuse a wheelchair ramp?
A landlord cannot unreasonably refuse consent for a disabled tenant to make adaptations such as a ramp where the tenancy requires consent for improvements, under the Equality Act 2010. The landlord may impose reasonable conditions, such as reinstatement at the end of the tenancy. Ask for consent in writing and keep a record of the response.
How wide should a wheelchair ramp be?
For non-domestic buildings, Approved Document M guidance recommends a minimum clear width of 1.5 metres between handrails, allowing people to pass. For domestic ramps, a clear width of at least 900mm to 1 metre is common, but wider is better for turning and for carers walking alongside. Powered chairs and scooters may need extra width.
Are aluminium ramps slippery when wet?
Quality aluminium ramps have slip-resistant textured or perforated decking that drains water and gives grip in wet conditions. Leaves, moss and ice can still make any ramp slippery, so keep it swept and grit it in freezing weather. Some systems offer anti-slip coated surfaces for extra grip on exposed or shaded sites.
Can a ramp be fitted to a rented home?
Yes, ramps can be fitted to rented homes with the landlord's consent. Modular aluminium ramps are popular for rentals because they need no groundwork and can be removed later without leaving damage. Council and housing association tenants should contact their landlord or the council adaptations team, who may arrange the work.
Get a free disability ramp installation quote
Tell us what you need and we'll come back with a clear price.
Request a quote