Guide · Homeowners and businesses · 4 min read · Updated 17 November 2026
Wheelchair Ramp Gradients and Regulations: UK Guide
Short answer
In England, Approved Document M gives ramp guidance for buildings other than dwellings, with maximum gradients ranging from 1:20 for longer runs to 1:12 for short runs. Ramps should have level landings at the top and bottom, resting landings on longer runs, a slip-resistant surface, handrails on both sides and a raised edge on any open side. Home ramps are not always legally bound by these figures, but they are the best design benchmark.
What a gradient of 1 in 12 actually means
A ramp gradient is written as a ratio of rise to length. A 1 in 12 gradient, written 1:12, rises one unit for every twelve units along the slope, so a 100mm rise needs 1.2 metres of ramp. A 1 in 20 gradient is much gentler and needs 2 metres of ramp for the same 100mm rise. The steeper the ramp, the harder it is to push a wheelchair up and the harder it is to control coming down.
Approved Document M links the steepest acceptable gradient to the length of the ramp. Short ramps can be steeper because the effort is brief, while long ramps must be gentler so users do not tire. As a rule of thumb, 1:12 is the steepest gradient for a short ramp, and gentler slopes such as 1:15 and 1:20 apply as the run gets longer.
| Rise to overcome | Ramp length at 1:12 | Ramp length at 1:15 | Ramp length at 1:20 |
|---|---|---|---|
| 100mm | 1.2m | 1.5m | 2.0m |
| 150mm | 1.8m | 2.25m | 3.0m |
| 300mm | 3.6m | 4.5m | 6.0m |
| 450mm | 5.4m | 6.75m | 9.0m |
Where the regulations apply
Approved Document M of the Building Regulations in England covers access to and use of buildings. Its detailed ramp guidance, including the gradient limits, landings, widths and handrails, applies to buildings other than dwellings, such as shops, offices, surgeries and schools, when new work is carried out. New homes have their own access requirements under the same document, focused on approach routes and entrances.
For an adaptation to an existing private home, a modular or permanent ramp is not usually controlled by the Building Regulations in the same way, but the Approved Document M figures are still the most reliable benchmark for a safe design. Occupational therapists and experienced installers generally design to them, adjusting only where space makes it impossible and the user's needs allow.
Landings, width and edges
Landings matter as much as the slope. A ramp needs a level landing at the bottom and at the top, big enough for a wheelchair user to stop, turn and open the door without rolling back. Where a door opens outward over the top landing, the landing has to be larger so the user can move clear of the door swing. Longer ramps need intermediate resting landings so that no single run is too long.
Width needs to suit the user and the setting. Public building ramps are expected to be generous so that people can pass, while home ramps can be narrower provided the user's wheelchair, any carer walking alongside and the handrails all fit. Any side of a ramp or landing that is not against a wall should have a raised kerb or edge to stop wheels or walking aids slipping off.
- Level landing at the top and bottom of every ramp.
- Extra landing space where a door opens outward.
- Intermediate landings on longer runs.
- Raised kerb or edge on open sides.
- Width to suit the wheelchair, any carer and the handrails.
Handrails and surfaces
Handrails help people who walk with sticks, frames or limited balance as much as wheelchair users. Approved Document M expects handrails on both sides of ramps in non-domestic buildings, continuous across landings where practical, at a comfortable height above the ramp surface and extending beyond the top and bottom of the slope so users are supported as they step on and off. The rail should be easy to grip and should not get too cold or hot to hold.
The surface must be slip-resistant in wet weather. On permanent ramps this usually means a brushed concrete finish, textured paving or a resin-bound surface. Modular aluminium ramps use ribbed or coated decks. Good drainage is essential, because standing water on a ramp becomes a slip and ice hazard, and visual contrast at the top and bottom helps people with sight loss.
Duties for businesses and service providers
The Equality Act 2010 requires service providers to make reasonable adjustments so that disabled people are not put at a substantial disadvantage. For a shop, café, surgery or office with a stepped entrance, providing a ramped entrance can be one of those adjustments. What is reasonable depends on factors such as cost, practicality and the size of the business, but the duty is anticipatory, meaning providers should think ahead rather than wait for a complaint.
Where a permanent ramp is built as part of alterations to a non-domestic building, Building Regulations approval may be needed, and the design should follow Approved Document M. A portable ramp kept behind the counter is sometimes used where a permanent ramp is not possible, but it must be suitable for the step and staff must know how to set it up safely.
Steeper than recommended: what to do
In many homes there is simply not enough room for a ramp at the recommended gradient. Rather than accept a steep ramp that is unsafe or unusable, there are alternatives. A switchback design can fit more length into a narrow front garden. Raising the path level gradually from further back can reduce the rise at the ramp itself. Using a different entrance, such as a side or back door with a lower threshold, sometimes solves the problem.
Where the rise is too great for any ramp, a step lift or through-floor lift may be the better adaptation. An occupational therapist can help weigh these options, and their assessment is usually needed for a Disabled Facilities Grant in any case.
Questions people also ask
What is the maximum gradient for a wheelchair ramp in the UK?
Approved Document M guidance for buildings other than dwellings in England sets 1:12 as the steepest gradient, and only for short ramps. Longer ramps must be gentler, down to 1:20 for the longest runs. For home ramps, the same figures are used as the safest benchmark wherever space allows.
How long does a ramp need to be for three steps?
Three standard steps are typically around 450mm high. At a 1:12 gradient that needs about 5.4 metres of slope, and because longer ramps should be gentler, the real design may be longer still, with intermediate landings. In a small front garden, a switchback layout is often used to fit that length.
Do home ramps need Building Regulations approval?
A modular ramp or simple permanent ramp added to an existing private home does not usually need Building Regulations approval in the same way as work to public buildings. Larger structures, raised platforms or changes to doors and openings may involve other controls, and planning permission can apply to raised sections over 0.3 metres.
Written and checked by the Disability Ramp Installation team. Read our editorial policy.
More guides
How Much Does a Disability Ramp Cost in the UK? 2026 Price Guide
A fitted threshold ramp costs £60–£250 in the UK in 2026. A modular aluminium ramp for a single step typically costs £800–£1,800, and for two or…
Disabled Facilities Grant for a Ramp: How to Apply and What It Covers
A Disabled Facilities Grant is money from your local council towards adaptations that help a disabled person live at home, including ramps, handrails…
Modular Aluminium vs Concrete Wheelchair Ramps: Which Is Best?
Modular aluminium ramps suit people who need access quickly, rent their home or expect needs to change, as they install in about a day and can be…
Do You Need Planning Permission for a Disabled Access Ramp?
Many small home ramps do not need planning permission, but in England a raised platform more than 0.3 metres above ground level is not permitted…
Get a free disability ramp installation quote
Tell us what you need and we'll come back with a clear price.
Request a quote